Sterra X — Cannot Dispense Hot WaterUpdated 2 days ago
If your Sterra X is no longer dispensing crisp, cold water, the internal cooling engine (the compressor) may have paused to protect itself from overheating, or a rear toggle switch might have been accidentally flipped off during cleaning.
Follow these 4 simple steps to check your settings and reset your cooling system:
The Cold Water Calibration & Reset Protocol
1.1. Check the rear cooling switch: Verify baseline settings.
Locate the black rocker switch on the back panel of your Sterra X. Ensure it is switched completely to the ON ( I ) position. If this switch was accidentally toggled off, the cooling engine will not activate.
2.2. Inspect ventilation clearances: Prevents thermal trapping.
Take a look around your machine. Your Sterra X requires a minimum of 10cm to 15cm of open space on all sides (especially the back). If it is pushed flush against a wall or cabinet, heat gets trapped inside, preventing the system from chilling your water. Move it forward to restore airflow.
3.3. Execute a 2-hour electrical drawdown: Drains system memory.
Turn the power switch OFF and completely unplug the Sterra X from the wall socket. Leave the machine entirely disconnected and resting for at least 2 full hours. This allows internal gas pressures to drop back to baseline and cools the motor down completely.
4.4. Re-power and monitor the chill: Verify refrigeration.
Plug the machine directly back into a main wall socket and turn it on. Wait 45 to 60 minutes to give the compressor enough time to cycle through a full cooling run. Dispense a glass to check if the water temperature has dropped.
Still dispensing warm or room-temperature water?
If you have verified that the rear switch is on, there is plenty of wall clearance, and the unit has completed its 2-hour rest, but the water remains un-chilled, your Sterra X has a faulty cooling thermostat or a broken compressor motor.
Please reach out to our Customer Support Team so we can assist you further!
Log in to our Customer Support Portal.
Submit a support ticket describing the issue.
Attach a short video (at least 1 minute long) showing the error happening. This will help our technical team diagnose and resolve the issue much faster for you.
Thank you for your patience, and we look forward to getting this sorted out!